跳至內容

Concrete finishing · Toronto & GTA

Grind & Seal Concrete

Mechanically ground concrete protected with a compatible clear sealer—preserving the slab’s natural colour, aggregate and honest variation.

Natural concrete finish

Reveal the slab instead of covering it

Grind & Seal removes the weak or contaminated surface, exposes the existing concrete to the agreed degree and protects it with a clear sealer. The finished character comes from the slab already in the building.

It is a practical choice for clients who appreciate natural variation, visible aggregate, repaired cracks and an industrial or contemporary appearance.

Set the right expectation

The concrete decides much of the final appearance

Aggregate Exposure

Stone size and distribution vary. Edges, patches and different pours may expose differently.

Colour Variation

Concrete tone, curing, age, previous coverings and contamination create natural colour shifts.

Cracks & Repairs

Practical repairs remain visible and often become part of the finished industrial character.

Flatness

Grinding follows the slab; it does not automatically level waves, correct slope or redesign drainage.

Perimeter Difference

Hand-ground edges may not match the exposure produced by larger equipment in open areas.

Maintenance

Sealers wear with traffic and cleaning. Periodic maintenance or recoating may be required.

Know the difference

Grind & Seal vs. polished concrete

Grind & Seal

Protected by a topical sealer

  • Fewer mechanical refinement stages
  • Sheen comes mainly from the sealer
  • Generally shorter installation schedule
  • Sealer is a wear layer requiring maintenance

Polished Concrete

Mechanically refined surface

  • Multiple progressive grinding and polishing stages
  • Densifier strengthens the prepared surface
  • Sheen develops through mechanical refinement
  • More equipment, labour and installation time

The two systems can look similar in photos but are not the same process, performance profile or price category.

Installation process

Mechanical preparation with a clear finish

  1. 1

    Assess the slab

    Review coverings, adhesive, coating, repairs, moisture, access and desired exposure.

  2. 2

    Remove surface material

    Mechanically remove compatible coatings, adhesive residue or weak concrete as scoped.

  3. 3

    Diamond grind

    Use selected tooling and passes to create the agreed appearance and surface profile.

  4. 4

    Repair + detail

    Treat practical cracks and defects, then complete edges and transitions.

  5. 5

    Clean thoroughly

    Vacuum and prepare the floor for compatible sealer application.

  6. 6

    Apply sealer

    Install the selected clear system and provide curing and maintenance guidance.

Project expectations

Schedule, use and quotation factors

2–4 days

Typical installation

Coating removal, adhesive, heavy grinding, repairs and large areas can extend the schedule.

24–48+ hours

Light foot traffic

Return-to-use depends on sealer chemistry, ventilation, temperature and written instructions.

Natural variation

Not a manufactured pattern

Mockups help establish direction but cannot predict the entire slab’s exposure and colour.

What affects the quotation?

  • Total area, rooms and access
  • Existing tile, coating or adhesive removal
  • Required grinding depth and number of passes
  • Concrete hardness and condition
  • Crack repair and patching
  • Edges, stairs and equipment limitations
  • Interior or exterior sealer selection
  • Night work or operating restrictions

Oil, salts and historic contamination can penetrate deeply and may remain visible or affect sealer acceptance. Active moisture or water-entry issues require separate correction.

Grind & seal estimate

Show us the existing concrete

Send wide and close-up photos, approximate area, current covering or coating, intended use and preferred appearance.

416-720-5724
sapphirehomeupgrades@gmail.com